Search
Now showing items 1-10 of 12
Unequal-Biaxial Taut States of Electro-Active Polymeric Composites
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Existing studies on wrinkling, an instability phenomenon commonly observed on electro-active polymers (EAP), have largely ignored the unequal-biaxial taut states, focusing instead on the equal-biaxial deformations of such ...
Effect of Spatially Varying Magnetic Field on the Cooling of an Electronic Component by Natural Convection With Magnetic Nanofluids
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Natural convection cooling of an electronic component in an electronic device using water-based Fe3O4 magnetic nanofluids is studied under the presence of the magnetic field. The heated vertical electronic component in an ...
Finite Element Modeling of Electromagnetic Crimping of Cu-SS Tube-to-Tube Joint Along With Simulation of Destructive Testing for Strength Prediction of the Joint
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This work explores the tube-to-tube joining of copper (outer) and stainless steel (inner) using electromagnetic crimping. Stand-off distance is kept constant during all the experiments. ls-dynaTM electromagnetic module, ...
Development of Nanocomposite Grease: Microstructure, Flow, and Tribological Studies
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Greases are widely used for variety of applications at extreme pressures, temperatures, and speeds with obligation of high bearing and shaft life with low noise. The present study deals with the development of nanocomposite ...
Tribological and Vibration Studies on Newly Developed Nanocomposite Greases Under Boundary Lubrication Regime
Publisher: The American Society of Mechanical Engineers (ASME)
Tribo-Dynamics of Nanocomposite Grease Lubricated Point Contact Under Elastohydrodynamics Lubrication Regime
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Friction is usually induced when the contacts are in relative motion, leading to mechanical vibration and consequently heat generation. The reduction of these undesirable parameters is possible by the application of greases, ...
Rheological and Film Forming Behavior of the Developed Nanocomposite Greases Under Elastohydrodynamics Lubrication Regime
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Performance of grease lubricated point contact under elastohydrodynamics lubrication (EHL) regime is critical in many engineering applications. The present work deals with the evaluation of rheological, film forming ...
Experimental Investigations on the Tribological Performance of Electric Discharge Alloyed Ti–6Al–4V at 200–600 °C
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Nowadays, the titanium alloys observe broad applicability in aerospace, marine, automobile, and bio-medical industries due to their lightweight, bio-compatibility, good fatigue strength, and corrosion resistance. However, ...
Effect of Confinement on Flow Around a Rotating Elliptic Cylinder in Laminar Flow Regime
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The flow phenomena around a rotating elliptic cylinder placed in a narrow channel is studied numerically. The walls of the channel act as a confinement that limits the flow in the transverse direction. The confinement ratio ...
Melting and Heat Transfer Characteristics of Phase Change Material: A Comparative Study on Wire Mesh Finned Structure and Other Fin Configurations
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In the present paper, a two-dimensional transient numerical study has been performed to investigate the influence of different fin designs on the melting and heat transfer characteristics of a phase change material (PCM), ...